The end of the Plug and Play MIMA, and MIMA2
MIMA introduction
MIMA Operation
MIMA Users Page
Installing MIMA with The Plug and Play harness
FAQ
Installing MIMA with the pin replacement harness
Installation and introduction
1. Disassembly
2. Installing the harness tubes
Make sure that the main HV switch is turned off
Remove the cover of the emergency brake.
Removing the aluminum extrusion behind the seats
Wiring tubes
Install rear wiring tube
Threading the front wiring tube
3. Threading the Harness
4. Removing the pins from the Multilock connectors
5. Installing the rear connections
6. Mounting the MIMA system in the car.
7. Accessing and connecting to the ECM
8. Overall wiring test
9. First power up test
10. The first MIMA operational test
11. Confirming temp probe and fan control operation, and final checkout
12. Mounting the low profile display
13. Removing the MIMA harness
software
The MIMA Joystick
The MIMA Display
The FAS system
DIY MIMA L
Cable impedance problem with last MIMA systems.
Learning to drive with MIMA
Hardwired Harness
Theory of Operation

Wiring tubes

Wiring tubes
Wiring tubes

To make the installation/removal of the harness easier, and to offer more protection for the wires, I am including two wiring tubes.The tubes can be left in place if the harness needs to be removed, to aid in the re-installation.