The end of the Plug and Play MIMA, and MIMA2
MIMA introduction
MIMA Operation
MIMA Users Page
Installing MIMA with The Plug and Play harness
Installing MIMA with the pin replacement harness
The MIMA Joystick
The MIMA Display
The FAS system
Cable impedance problem with last MIMA systems.
Learning to drive with MIMA
Hardwired Harness
Level 1 Installation
Level 2 install
Removing the ECM
ECM C-28 Yellow/blue wire to MIMA ECM ribbon Orange wire
ECM C-27 Red/Black wire to MIMA ECM ribbon Gray wire TPS
ECM C-18 Green/Black wire to MIMA ECM ribbon Violet wire TPS
ECM C-19 Yellow/Red wire to MIMA ECM ribbon Blue wire MAP +V
ECM C-17 Red/Green wire to MIMA ECM ribbon Black wire MAP
ECM C-7 Green/White wire to MIMA ECM ribbon White wire MAP gnd.
Level 2 test.
Theory of Operation
First we will connect the wires to the ECM side of the cable. Carefully strip an area of the insulation of the target harness wire by prying the insulation back without cutting any strands of wire. Then using the same twist solder and tape techniques as all the other wires, make the six connections. This is the most difficult step of the whole installation, as the harness is in a bad place to work comfortably. I found it easiest to kneel on a soft cloth just outside the open passenger door while leaning into the car to make the connections.