The end of the Plug and Play MIMA, and MIMA2
MIMA introduction
MIMA Operation
MIMA Users Page
Installing MIMA with The Plug and Play harness
Installing MIMA with the pin replacement harness
The MIMA Joystick
The MIMA Display
The FAS system
Cable impedance problem with last MIMA systems.
Learning to drive with MIMA
Hardwired Harness
Level 1 Installation
Level 2 install
Removing the ECM
Level 2 test.
PIMA test
Theory of Operation

PIMA test

Re connect the MIMA controller. The car should start normally, but we may have triggered another code with the disconnected wires, If so follow the reset procedure.

Take the car for a ride. Try pressing the mode 2 button when the car is moving less than 15 MPH. the mode light should flash in, then go right back off. Increase speed to over 25MPH. Tapping the mode 2 (PIMA) switch should light the second mode led, and allow the PIMA to work with the default settings. You should see assist come on when you step down on the gas, and charging when you let up. Jog the settings to your liking. See more on operating MIMA .