The end of the Plug and Play MIMA, and MIMA2
MIMA introduction
MIMA Operation
MIMA on demand and MIMA Active (mode1)
ABC level jog
ABC setpoint jog
Mode 2(PIMA)
PIMA, Mode 2 jog calibrate during operation
Setting the mag factor
PIMA, Mode 2 calibrate mode
Joystick Configuration & Calibration
MIMA Users Page
Installing MIMA with The Plug and Play harness
FAQ
Installing MIMA with the pin replacement harness
software
The MIMA Joystick
The MIMA Display
The FAS system
DIY MIMA L
Cable impedance problem with last MIMA systems.
Learning to drive with MIMA
Hardwired Harness
Theory of Operation

ABC setpoint jog

ABC setpoint jog
If the joystick is jogged to either jog left, or jog right, and the central switch is pressed while in that position, the mode 1 LED will flash quickly, to indicate that the jog function has switched to jog ABC set point sub mode. In this sub mode, a jog left will move the ABC activation point to a lower MPG to allow the activation at this lower MPG. A jog right will move the activation point to a higher MPG point. To revert back to the jog ABC level, again press the central button while jogging either up or down, or simply tap out of mode 1, and then back into mode 1, as the level jog is the default for this mode.